RC68. My Memory Having RC Car. My no 44 RC car. Victory Hawk VH32 Thunder 2010.

After waiting another week i ask again for this Victory Hawk VH32 for RM180. At last this owner from sungai buluh accepts my offer but no battery given. This is a 2010 China made RC Victory Hawk VH32 Thunder 4wd shaft system. No much information about this units. Never new this rc until know. Even the saller don't know what brand. I just take few days serching for this RC in Internet and found it.

Start blogger = 1/12/2022

Update blog  = 4/10/2023

Sum spending on parts = RM8.50

2010 to 2024 = 14 Years

Made in CHINA (🇨🇳)

 

All image below not mine just to show this RC products.

 With FERRARI body 

There is a instruction Manual but can't find in pdf.

Fault Found 

1. No body given

2. Using a Am remote

3. Build in Brush motor

4. Very dusty

5. All Tyre not glue to rim

6. All wheels no ballbearing 

7. Wheel Hex using plastick will stuck when over tighten the wheel.

8. Front center shaft seal with tape prevent the center shaft pin came out

9. No ballbearing on axle

10. Loose Proppeler shaft pin

11. All the front/rear suspension arm using screw to make higher not allen screw.

12. Front and rear axle not using ballbearing.

From saller image that post for sale

2/12/2022 Got the RC not in my hand yet, With my runner.

29/12/2022 got this units will slowly review. Look like this rc buy new and just play and didn't upgrade. When i open all screw, it tight and some loose. All tyre not glue to rim, drive gear ok. No ballbearing on all wheels, use plastic hex. Try up still running but reverse slow. No assembly manual given or in pdf file slowly assemble back according photo taken. All wheel will fitted ball bearing soon order from china.

Build in brush motor

Victory Hawk VH3810 servo and R3820 am receiver.

Shock not oil type

The tyre tread still ok, no side damage

Under chassis lest scratch 

Both gear ok

Imitation of Futaba Remote

HuaYing tyre

All tyre not glug

All wheel using coper bushing 

Bumper form in good condition 

Only dusty

Body post in good condition 

No ballbearing 

Rear axle

The shortes Proppeler shaft, one pin loose 

Using tap on the shaft bracket because Proppeler shaft pin loose.

Drive Shaft using dogbone 

Center Shaft using ballbearing 

The steering linkage no ballbearing 

Greese no dry 

Not using ballbearing 

 Greese not yet dry and gear no damage

All dismental gear ok

The adjusment high using Screw not alen screw

All dismental 

Soak in detergent loosen the dirt

Next after cleaning and assembly soon

Fully service and add ballbearing 

Done front/rear axle

The Beast Speed Racing

Build in brush, internal spray with WD40 to clean the carbon.

Done

17/1/2023. Change all wheel using ball bearing.

17/1/2023. All wheels using 5mm aluminium Hex.

Next wheels alaiment 

Rear camber o

Front toe in -2

All 100% clean, only no body will buy one for it. Also all wheels ballbearing 4x10x4 8 pcs. No broken parts, another collection of my RC 

New body Toyota

Enjoy RC and have fun 👍